B1 fuse blown, need help
05-16-07, 02:52 PM
#1
Paper mache seals
Thread Starter
iTrader: (1)
Join Date: Apr 2006
Location: Linthicum
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
B1 fuse blown, need help
I hit a bump in the road last night and it blew the b1 fuse. Ive looked through the wiring shematic and there is enough **** coming off that fuse that I was just hoping someone would at least have a place I should start looking. Any suggestions???
05-16-07, 04:47 PM
#3
Paper mache seals
Thread Starter
iTrader: (1)
Join Date: Apr 2006
Location: Linthicum
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
I keep finding wires that are all jacked up but after I fix it I am still getting continuity between the fuse and ground, so the problem is not fixed.
Trending Topics
05-18-07, 09:07 AM
#8
Full Member
Join Date: Jan 2003
Location: Superior, WI
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Check the wires above the inner fender lining. they could have got pinched up against the steel if your wheel got pushed up far enough. Although if you don't have any rubbing problems on your liner then disregard this reply.
-Spence
-Spence
05-18-07, 02:07 PM
#9
Paper mache seals
Thread Starter
iTrader: (1)
Join Date: Apr 2006
Location: Linthicum
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
the liner there is gone anyway. Im sure thats where it is now. After checking my diagrams and tracing every connector, Im only getting continuity between the ground and the connectors that show up after it goes through the fender.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM
