850cc Modified Primary Fuel Rail Pictures
#1
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Tokyo/Texas
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
I thought that I would put this up for reference for people searching on the matter. My brother's FD is running 850cc in both his primary and secondary rails, and I am currently working on installing 850cc's into my primaries as well. His rail was modified by Rotary Performance, but I was too cheap to pay to have them modify mine, so I'm just doing it myself and using his as reference. They told me all that needs to be done is shave 1/8" off the top of the primary injector holder and they'll work perfect, which they have been for about 8,000 miles on my brother's car. If you do this, there's no need for additional O-rings or anything else. I was able to pull his pimary rail out in about 30mins since his car is non-sequential, but mine being sequential took much longer. I know there have been other posts on the matter, but I thought I would put up some pictures for reference. Hope it helps somebody out eventually.
Trending Topics
#8
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Tokyo/Texas
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
I'm having a lot of problems posting.....hopefully I can get them up in a little. Taking me 10 minutes to upload a post like this. Sorry.
Last edited by Spool Up; 01-10-04 at 01:44 AM.
#9
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Tokyo/Texas
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
seems to be working now.
This is a side view. You can see they shaved it down 1/8" inch compared to the stock. Rotary Perfomance shaved one on left and stock on right.
This is a side view. You can see they shaved it down 1/8" inch compared to the stock. Rotary Perfomance shaved one on left and stock on right.
Last edited by Spool Up; 01-10-04 at 02:34 AM.
#10
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Tokyo/Texas
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
Top view of the shaved area. Again, RP shaved one on left, and stock on right. You can tell it's shaved down as more material is showing on the surface of the RP one.
#11
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Tokyo/Texas
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
Just a picture of them back to back.
Roar 629....my mods are as follows:
Greddy SMIC
Full 3" turbo back Exhaust w/ high flow cat
RE Amemiya Intake
Bosch Fuel pump
Power FC
Turbos still set up sequentially
Roar 629....my mods are as follows:
Greddy SMIC
Full 3" turbo back Exhaust w/ high flow cat
RE Amemiya Intake
Bosch Fuel pump
Power FC
Turbos still set up sequentially
Last edited by Spool Up; 01-10-04 at 02:55 AM.
#14
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Tokyo/Texas
Posts: 685
Likes: 0
Received 0 Likes
on
0 Posts
I'm not selling anything here.....I thought I'd just post some pictures so if people go to do the same modification to their car, they'll have some sort of pictures for reference.