Is it ok to shave .5 inch or 1 inch off the stock 91 coupe shift rod??
#2
Eats, Sleeps, Dreams Rotary
iTrader: (4)
Join Date: Apr 2003
Location: Denver, NC
Posts: 3,531
Likes: 0
Received 0 Likes
on
0 Posts
sure trying to make a short ahifter? or do you have a **** that is to tall for the shift leather boot to reach? I had that happen with a FD and just cut it down after the owner asked me to do it. It worked fine still and the throw is the same.
#4
Jesus is the Messiah
Suds had the top part of his S5 shift lever break clean off.
So about 1 inch of the rod was sticking out, and he put an aftermarket **** on that.
Yeeeehhh
So about 1 inch of the rod was sticking out, and he put an aftermarket **** on that.
Yeeeehhh
#5
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
The only trap is most aftermarket ***** have undersize set screws.
That can be fixed by tapping them out for a larger set screw.
That's a short piece of heater hose to seal the boot.
That can be fixed by tapping them out for a larger set screw.
That's a short piece of heater hose to seal the boot.
Last edited by SureShot; 01-24-05 at 07:56 AM.