When you got too much time on your hands, my 86-88 FC code reader!
#1
When you got too much time on your hands, my 86-88 FC code reader!
I used the plans that i found on FC3S Pro v2.0:  How-To - Zenki FC3S Error Codes
Cleaner than just wires and leds soldered together!
Total time, about 2 hours! Tested and working great! Total cost less than 5$!
Cleaner than just wires and leds soldered together!
Total time, about 2 hours! Tested and working great! Total cost less than 5$!
#5
NA-BOOSTIN
So just a question really I've always wanted to ask over the years but never did . Can you is just s normal light bulb or does it have to be led . May seem Dumb I know lol
#6
MECP Certified Installer
Has to be LED, the transistors that switch it on and off can't support more than 150mA. A light bulb would exceed that by an exceptional factor.
Thread
Thread Starter
Forum
Replies
Last Post
OleKnees
New Member RX-7 Technical
15
03-12-16 10:12 PM