4.77 + Ring & Pinion Gear Sets!
#1
Senior Member
Thread Starter
4.77 + Ring & Pinion Gear Sets!
For those of you that really want to kick your acceleration up a few notches...
Solomiata : Drivetrain : Interchange
Solomiata : Transmission : Ring and pinion tooth counts
I recently picked up a set of 5.38 gears for a KIA Sportage front diff. AKA for my next SA/FB project. The pinion gears could also be grafted onto an FC's long pinion....
I had to order from Korea, thx to some info I found here: 5.38 ring and pinions - 4x4Wire TrailTalk
picorp@hanmail.net <-That's the contact email for gear sets. Cost me $287.00 and they are VERY quick. I paid 02/09/17 @ 8PM PST it was on an airplane flying out of S. Korea by the 11th and I had the gears in hand by the 14th or 15th.
Solomiata : Drivetrain : Interchange
Solomiata : Transmission : Ring and pinion tooth counts
I recently picked up a set of 5.38 gears for a KIA Sportage front diff. AKA for my next SA/FB project. The pinion gears could also be grafted onto an FC's long pinion....
I had to order from Korea, thx to some info I found here: 5.38 ring and pinions - 4x4Wire TrailTalk
picorp@hanmail.net <-That's the contact email for gear sets. Cost me $287.00 and they are VERY quick. I paid 02/09/17 @ 8PM PST it was on an airplane flying out of S. Korea by the 11th and I had the gears in hand by the 14th or 15th.
#2
Stu-Tron Get Yo Groove On
iTrader: (4)
Here is a link for 4.77 R&P for the sportage
Hyundai/Kia SPORTAGE GEAR SET-FINAL 0K01427110 MM05727110
$222.86
How is that 5.38? What trans are you using behind that? You must rip through the gears with that!
Hyundai/Kia SPORTAGE GEAR SET-FINAL 0K01427110 MM05727110
$222.86
How is that 5.38? What trans are you using behind that? You must rip through the gears with that!
#3
Senior Member
Thread Starter
I actually haven't installed them in anything, YET... fell off the Rx-7 thing for bit...
The following users liked this post:
fbse7en (12-08-22)
#5
Senior Member
Thread Starter
LMAO, yeah it's been a minute...it's time to get back on the rotary wagon! -I'll post here again once I finally do. (Lookin' at getn another FB...)
Thread
Thread Starter
Forum
Replies
Last Post
TurboIIGuy
1st Generation Specific (1979-1985)
4
04-06-05 11:01 PM